Can you mount a TV on brick veneer?

Yes, but you must hit the studs behind the veneer, not the veneer itself — the veneer is too thin to hold a TV alone. This requires longer fasteners and a stud finder rated for masonry.

Will mounting a TV on brick crack it?

Not if you use a hammer drill, the right masonry bit, and you drill slowly with light pressure. Cracks happen from the wrong drill type or hammering instead of drilling.

What's the best anchor for brick?

Sleeve anchors or wedge anchors rated for 4× the TV weight. For most TVs that's a 3/8" anchor minimum.

QuickMountTV™ · Blog · Wall Types

How to Mount a TV on a Brick Wall (The Right Way)

Brick walls scare DIYers and they shouldn't. With the right tools, mounting a TV on brick is actually easier than mounting on drywall — there's no stud-finding involved and the holding strength is enormous. The mistakes happen in three places: choosing brick face vs mortar, the drill bit, and the anchor.

Brick face or mortar joint? Pros disagree, here's why

Drilling into the brick face gives maximum holding strength but risks cracking the brick if your bit slips or the brick is older/softer. Drilling into the mortar is easier on the brick and is repairable later (mortar can be patched; cracked brick can't), but mortar is softer and slightly weaker. Most pros split the difference: face for new, hard brick on a fixed bracket; mortar for older brick or any time the install might come down later (renters take note).

The exact tools and hardware

Hammer drill (not a regular drill — you'll burn out a regular drill on brick).
Carbide-tipped masonry bit sized to your anchor. Skip the multi-purpose bits.
Sleeve anchors or wedge anchors rated for at least 4× the TV's weight. Plastic anchors don't belong in brick.
Dust shroud or shop-vac held against the wall by a helper. Brick dust gets into everything.
Painter's tape over the drill point — keeps the bit from wandering and catches initial dust.

Cable management on brick

You can't fish cables through brick the way you can through drywall. Three real options: (1) run cables in a paintable cord channel along the brick (cheapest, looks fine), (2) drill through the brick to the back of the wall and pull cables through (only if you have rear access), or (3) install a recessed power kit on the drywall section above the brick if your wall is mixed.

When to absolutely call a pro

Old historic brick (pre-1940), brick veneer over a sheathing/stud system rather than solid masonry, brick fireplaces with active flues, or any brick wall that's load-bearing for a chimney structure. The risk of cracking a brick or hitting something you shouldn't is real, and the repair cost dwarfs the install cost.

Frequently asked

Can you mount a TV on brick veneer?: Yes, but you must hit the studs behind the veneer, not the veneer itself — the veneer is too thin to hold a TV alone. This requires longer fasteners and a stud finder rated for masonry.
Will mounting a TV on brick crack it?: Not if you use a hammer drill, the right masonry bit, and you drill slowly with light pressure. Cracks happen from the wrong drill type or hammering instead of drilling.
What's the best anchor for brick?: Sleeve anchors or wedge anchors rated for 4× the TV weight. For most TVs that's a 3/8" anchor minimum.

Book a pro install

Skip the DIY: book a licensed, $2M-insured QuickMountTV™ technician at quickmounttv.fieldd.co. Same-day appointments, flat-rate pricing, 3-year workmanship warranty.

Related guides

Book a pro in your city

Find a TV mounting pro near you →